The design considerations of bearing selection, bearing fits, bearing installation, and thermal control are discussed for a gimbal with a high stiffness, low friction torque requirement. Tradeoffs between a quad set of small diameter spread apart or a large diameter bearing pair resulted in a cleaner, lighter, stiffer unit with the latter selection. Bearing fits were designed to eliminate clearances with tolerances of .00127 mm 00005 in) on the bearing shafts and housings. The problems in metrology are discussed and a perferred technique for measurement of small cross-section bearings described. A technique for installation to assure proper seating of the bearing is offered. Where transient thermal conditions are involved, a method of controlling bearing friction by active control of bearing temperature gradients including the use of bearing unload test curves is described.
