Titan/Tough Extruder Arm with PC4 M10 fitting for PTFE tube (4590009)
Item Preview
There Is No Preview Available For This Item
This item does not appear to have any files that can be experienced on Archive.org.
Show all files
I have an E3D Titan clone (TH3D Tough) Extruder I'm installing on my Ender 5 and wanted a way to keep my filament dust-free and dry. The TH3D Tough extruder only allowed bare filament to feed through the top of their tough extruder arm so I remixed mihatomi's E3D Titan design in Tinkercad to fit my needs. This allows better fitment of the extruder arm bearing (10mm x 4mm thick) and fitment onto the TH3D supplied pancake stepper motor that the original design did not fit, as well as add a threaded adapter for a pass-through capricorn PTFE tube using a PC4-M10 fitting.
Leave orientation as-is, apply 1 support blocker to inside upper center of bearing recess. Bridging will be fine, supports will just muddy it up if you're even able to fish them all out.
I used 100% infill, 0.2 or 0.12 layer heights, supports everywhere, 0 support walls, and 7% support infill. Removes easily and cleanly. Use brim to promote adhesion and avoid accidentally knocking over print.
Approx 2-hour print time.
Pictures to come.
Leave orientation as-is, apply 1 support blocker to inside upper center of bearing recess. Bridging will be fine, supports will just muddy it up if you're even able to fish them all out.
I used 100% infill, 0.2 or 0.12 layer heights, supports everywhere, 0 support walls, and 7% support infill. Removes easily and cleanly. Use brim to promote adhesion and avoid accidentally knocking over print.
Approx 2-hour print time.
Pictures to come.
Reviews
There are no reviews yet. Be the first one to
write a review.
