I thought the designs I had seen for dry boxes could use some improvement for one reason or another. So, for this project I made new files with some improvements and put all the files you need for a complete a dry box in one place.
Printed parts: Filaments passthrough guide (3 parts) • Passthrough_Guide_Outer_v2 (threaded for a push in quick connects for 6mm Bowden tubes) • Passthrough_Guide_Inner • Passthrough_Cap_v2 (threaded to outer guide, will cover quick connect0 Spool holders (with press fit points for 608 ball bearings) • Spool_Holder_Threaded_End_XX (three lengths 35, 55, and 75mm) • Spool_Holder_Pocket_End Spool axle supports • Axle_Support_Inner_N_Degrees (six versions to compensate for tub draft angle) • Axle_Support_Outer_N_Degrees (six versions to compensate for tub draft angle)
Links for some of the purchased hardware are below. Other purchased hardware can be for at most hardware stores.
Purchased hardware you will need: A plastic storage tub big enough to hold your spools 8mm diameter rod - https://www.amazon.com/dp/B07DL2LMDX/?ref=idea_lv_dp_ov_d 608 ball bearings - https://www.amazon.com/dp/B07H84P2K1/?ref=idea_lv_dp_ov_d M4x0.7 machine screws, 16mm long M4x0.7 hex nuts
Optional purchased hardware: 1/8” PT male threaded 6mm push joint - https://www.amazon.com/dp/B01M01YMB1/?ref=idea_lv_dp_ov_d 6mm diameter PTFE Bowden tube - https://www.amazon.com/dp/B077XDYR74/?ref=idea_lv_dp_ov_d Silica gel desiccant - https://www.amazon.com/dp/B01I5Y2DG6/?ref=idea_lv_dp_ov_d Silicone sealant Rubber weather seal striping (if storage tub doesn’t come with it) M4 washers