A customizable 35mm Acrylic paint bottle holder for wall mounting. Fits standard 35mm Acrylic craft paint bottles. The slight angle allows you to keep the paint at the bottom of the bottle (or at the top if you put the bottle in cap first) without any chance of the bottles falling out. Bottles slip right in and out with just a slight resistance. I created a Single holder, a 1x3 and a 1x4, allowing you to arrange these in your slicer program in whatever configuration you want.. Just ensure the edges slightly overlap to ensure a single part print. You could also print them separately and super glue the edges together, or use a single screw to hold separate pieces together on the wall where the two half-holes line up. Note: the photos of my finished piece had a slightly different hole layout, but this kept them from sitting flush next to each other, so I changed it to the final design you see in the model Also, this will sit on a flat surface without tipping over, as long as you combine more than one row. You can also print this at 75% scale and it will fit the 25mm "dropper" style bottles from Vallejo ect.