Decided to go ahead and model up the Cockpit for this https://www.thingiverse.com/thing:2871232 fantastic Tie Interceptor model. All four pieces should print without supports (see image for bed layout). The Seat and Controls fit into two cutouts on the back of the Firewall for alignment , and then the Rear Bulkhead simply glues onto the back of the seat (see side image of 3d model). The entire glued up assembly then just slips into the Tie Interceptor. I modelled this based on images from the web and my own ideas, so no it's not accurate to the real thing, but I think it looks good especially at this small scale. I added the Step files incase anybody wants to edit them for themselves in any 3d modeling software to customize this.. ps, I printed my Tie Interceptor at 75% scale, so the images you see of my printed parts are also at 75% normal scale,, so they should look even better when you print them at 100% scale.