Hey, So I was too lazy (and cheap but keep that on the downlow) to buy one of those keyboard switch stem holders that all the youtubers and streamers use to hold their steps while lubing so I decided to make one.
2 days shipping! Thats outrageous! I can make this in 4 days minimum!
So I took my basic modeling skill to work and utilized a super rare component in the construction in this magnificent beast, *drum roll please*, the RUBBER BAND! This Stark Industry tech is the core of our Spring Loaded Plunger (TM) that allows for fast and easy stem ejac- I mean ejection. (check the reddit: https://www.reddit.com/r/MechanicalKeyboards/comments/mn350b/recently_joined_the_community_and_hated_holding/ )
**Print Directions** For the "Stem Holder" make sure to print on the surface that **DOES NOT** have the cross on it and **HAS** the ruber band holders aka the side with the end that the plunger enters into - I like to print the holder with a brim becuase I am scared that the surface area is too little for the tall print. Print the plunger on the wide cylindrical side with lots of surface area, not the teenie weenie cross side plz.
**Assembly Directions** 1) Once you have procured your state of the art RUBBER BAND (mine were too long so I doubled them over, you know twisting them and then folding them onto themselves) enter it into the slot and then into the angled section 2) Next insert the plunger, the sticky outy bids on the plunger go not on the same side as the rubber band holders, obv. 3) Stick in your stem, make sure that it is in the correct orientation becuase the north-south bits on the cross are thinner than the east-west cross bits 4) Finally lube and eject away!