I needed a case for my Octoprint Pi and I could not really find anything I truly liked. I needed something that I could mount to the front to route the camera and something I could get attached without taking anything apart. I had a case I used previously on my Ender 3 Pro and also a tool holder for my Ender 5 so why not combine the two?!?!
I borrowed the clip idea from https://www.thingiverse.com/thing:4510163 and also the case from https://www.thingiverse.com/thing:3016364.
I am using a heat sink kit and dual fan from Amazon, https://www.amazon.com/dp/B07RYK3J41?psc=1&ref=ppx_yo2_dt_b_product_details.
I removed the t slot bar from the case and replace it with the clips on the bottom. I also change the vent holes on the bottom to allow for venting above and below said clips. I also changed the PiCam slot to be much smaller to accommodate the cable but not leave so much open space. The fan mounts were removed and changed to vent slots to allow for cool air to enter into the case and help with the heat sink cooling.
I used supports touching build plate only for the bottom of the case so that the clips had supports but did not want to mess with the openings for the Pi connections.