Stock Cura Profile from Mingda was kinda bad and noisy so i spent some time calibrating and finding the right settings. Here I share my settings with you so you don't waste your time like me :-)
Just import the .curaprofile files. [Adjust Temperature & Enable Support as Needed]
for PLA and PLA+ is use the same profile. I managed to print PETG with minimal stringing with these profiles.
improvements are welcome :-)
Optionally you can also use my G-Code that adds a small line to the front (to check first layer and use babystep to get it right) and also strips off oozing filament. I added a Photo of how it will look like.
How i set up the Magician in Cura
First i added new Printer in Cura, selected "Artillery Genius" and renamed it (adds cool X-Ray of the Printer to Buildplate ) then edit the Settings like in the Pictures shown.
You can copy/paste G-Code from here:
Start G-Code: G21 ; use metric mm M107 ; Fan off G28 ; home all axes G92 E0 ; reset extruder G1 X2 Y7 Z0.5 F2000.0 ; move to start-line position G1 X2 Y70 Z0.5 F6000.0 ; fast move to G1 X2 Y7.0 Z0.3 F1500.0 E15 ; draw 1st line G1 X2 Y7.1 Z0.3 F1500.0 ; move to side a little G1 X2 Y7.1 Z0.3 F1500.0 E15 ; draw 2nd line :G1 Z1.0 F3000 ; move z up to prevent scratching of surface G92 E0 ; reset extruder
End G-Code: ;M400 ; Wait for current moves to finish M104 S0 ; turn off hotend/extruder heater M140 S0 ; turn off bed heater M220 S100 ; Set speed factor % to default M221 S100 ; Set extrude factor % to default G91 ; Relative Positioning G1 E-1.5 F300 ; Retract filament to prevent oozing G1 Z+2 F1000 ; move z up G1 E-1.5 F500 ; Retract more G90; Absolute positioning G1 X0 F3000 ; move X home G1 Y230 F1000 ; move bed forward for easier part removal M84 ; turn off Stepper M107 ; turn off Fan Changelog: 17.03.22 - updated gcode a bit and added PETG profile