Skip to main content
Internet Archive's 25th Anniversary Logo

View Post [edit]

Poster: Javik Date: Nov 29, 2006 12:34pm
Forum: petabox Subject: Re: Make that --144-- 2.5" drives on one SAS channel

Heh, SuperMicro has some really powerful products but their product info pages do not do a good job of explaining the full capabilities of the hardware.

If you take a look at the manual for the E1/E2 chassis you will see that it's not limited to 24 drives, but in fact up to 144 drives:

http://www.supermicro.com/manuals/other/CSE-M28E1-E2.pdf

Page 4 says:
w/potential support of up to 144 SAS devices (*Note)

*Note: The availability of SAS-devices supported depends on the readiness of firmware and hardware support. The firmware support and the hardware support for SAS devices are not validated at the time of publishing of this manual. It's subject to change.


And it seems that the main difference between the E1 and the E2 is that, as with the SC933 in my other post, the E2 has a redundant data channel to be used with SAS hard drives that have dual I/O ports on them.

So it looks to me that if you were to use just cheap SATA-II drives, you only need the E1 SAS backplane, as cheap SATA-II drives don't have the redundant I/O port available on the hotplug connector in the E2 chassis.


On page 8 of the backplane diagram, the E1 just has the four ports on the right side. The E2 has both the four on the right and the four on the left.

When cascading (daisy-chaining) the E1 chassis, two ports go to the SAS controller, and two ports are pass-through to the next E1 chassis.

When cascading (daisy-chaining) the E2 chassis, two ports go to one SAS controller, two ports to a second SAS controller, and four ports are pass-through to the next E1 chassis.

Meanwhile, if you only use one chassis, you can use all four (on the E1) or all eight (on the E2) to connect the single chassis to a single SAS card, though why you might do this is not explained.


I am assuming that when multiple SAS channels are used in parallel, it gives better performance. Perhaps it permits parallel drive accesses at 3.0Gbit, but again it is not explained.

An engineering degree in SAS technology may be required to understand all the hardware options available here. :-)

-Javik