3
3.0
Jun 11, 2021
06/21
by
Brett Thomas (BrettThomas)
data
eye 3
favorite 0
comment 0
Technically not a Remix, more of an accessory to Chuckmiester9's Awsome Raptor Engine. After finishing the engine build, it just didn't look right sitting directly on my bookshelf (who would set a rocket engine on the ground, so I decided it needed an official E.T.P. (Engine Transport Pallet). This model is based off of pictures at Boca Chica (see attached) and is fairly accurate, but not exact. There is a slit in the ring (under one of the 2 buckle blocks) that allow you to open it up to slip...
Topics: thingiverse, spacex, Vehicles, stl
2
2.0
Mar 16, 2021
03/21
by
Brett Thomas (BrettThomas)
data
eye 2
favorite 0
comment 0
Decided to go ahead and model up the Cockpit for this https://www.thingiverse.com/thing:2871232 fantastic Tie Interceptor model. All four pieces should print without supports (see image for bed layout). The Seat and Controls fit into two cutouts on the back of the Firewall for alignment , and then the Rear Bulkhead simply glues onto the back of the seat (see side image of 3d model). The entire glued up assembly then just slips into the Tie Interceptor. I modelled this based on images from the...
Topics: stl, thingiverse, Vehicles
2
2.0
Mar 15, 2021
03/21
by
Brett Thomas (BrettThomas)
data
eye 2
favorite 0
comment 0
My Wing-guns came out such a mess on this https://www.thingiverse.com/thing:2871232 excellent Tie Fighter, due to the wings flexing towards the top of the build. Even after trying to clean them up ( I broke one) they still looked like a mess, so I ended up cutting them off and then creating the attached gun.stl file in Meshmixer and then printing 4 copies laying flat on a raft.. super glue and a good eye will get them back on straight and looking better than before. Posted this in case anybody...
Topics: stl, thingiverse, Vehicles
