6
6.0
Jan 21, 2021
01/21
by
Sebastian Frost (FR0STI_92)
data
eye 6
favorite 0
comment 0
Its a screw that gets screwed into a drawer from the inside and hooks into a simple plastic rail to prevent the drawer from faling out.
Topics: thingiverse, screw, endstop, drawer, 3D Printing, stl
6
6.0
Jan 21, 2021
01/21
by
Sebastian Frost (FR0STI_92)
data
eye 6
favorite 0
comment 0
Its a simple little Endstop that gets pugged into a curtain-rail to prevent the curtain from sliding out again.
Topics: thingiverse, endstop, curtain, curtain_rail, 3D Printing, stl, stop
6
6.0
Jan 21, 2021
01/21
by
Sebastian Frost (FR0STI_92)
data
eye 6
favorite 0
comment 0
This is a towelhook. It is held to the wall by a hidden screw. Part one gets screwed to the wall with the little ''wings'' pointing to the sides and the flat surface pointing up. Than the part two just slides over it.
Topics: towel, hook, thingiverse, screw, towel_hook, Bathroom, towel_holder, stl, Hidden
9
9.0
Jan 19, 2021
01/21
by
Sebastian Frost (FR0STI_92)
data
eye 9
favorite 0
comment 0
I decided to place my screen in a seperat casing. This way the SD slot is better to reach and operating the printer while printing won't cause the whole printer to wiggle. However I was left with an ugly hole on top of the printer. To close it I simply designed a little cover which uses the whole for the operating knop as a fillament guide. Use some flathead screws or countersink them. The original screws of the ctc sometimes come to close to the printhead if you have a rly high print.
Topics: 3D Printer Parts, ctc_printer, clone, CTC_prusa_i3, thingiverse, prusa, cover, ctc, prusa_i3,...
9
9.0
Jan 19, 2021
01/21
by
Sebastian Frost (FR0STI_92)
data
eye 9
favorite 0
comment 0
A drillbitholder from 1.5 to 10 in steps of 0.5
Topics: toolholder, bit, Tool Holders & Boxes, tool, thingiverse, drillbit, holder, drill, stl
9
9.0
Jan 19, 2021
01/21
by
Sebastian Frost (FR0STI_92)
data
eye 9
favorite 0
comment 0
This is a segmented bitholder. The segments screw into each other and prevent the inserted bits to fall out. The thread is designed pretty tide to prevent the segments from losening. Sometimes if the printer isen't accurate enough it can appear a little to tight for the first assembly. Just screw it together a few times and it will get better or recut the inside threads with a M12 thread cutting tool. I just updated it now there is a 18 bit per segment version in addition to the 12 bit per...
Topics: tool_holder, bit, Tool Holders & Boxes, tool, thingiverse, bit_holder, stl, segmented
6
6.0
Mar 2, 2021
03/21
by
Sebastian Frost (FR0STI_92)
data
eye 6
favorite 0
comment 0
It's a Netilat Jadajim, a traditional jewish cup used for ceremonial purification of your hands.
Topics: Jadajim, jew, vase, jewish, purification, Yadayim, thingiverse, stl, religion, Cup, Other,...
