4
4.0
May 1, 2021
05/21
by
Ulrich Lachmuth (UliLac)
data
eye 4
favorite 0
comment 0
A small, quick'n'dirty solution for a mainly aesthetic problem. On my Ender 3v2 the Z stepper motor cable runs "in the open" and has a tendency to, over time, loop up from vibrations - bringing it quite close to the bed adjustment screws, creating a possible tangle hazard. Since I like my cables neatly tucked away as far as possible I created this easy-to-print and quite efficient cable cover for this cable. Hardware needed: M4x10 screw and 1 T-nut (was too lazy to come up with a...
Topics: stl, Z axis, stepper_motor, cable_management, 3D Printer Accessories, thingiverse
4
4.0
May 1, 2021
05/21
by
Ulrich Lachmuth (UliLac)
data
eye 4
favorite 0
comment 0
Mount post for a print bed light. The light in question consists of an ordinary USB extension cable and one of these nifty USB LEDs with a touch on/off/dim switch. The mount uses the two screws holding the Ender 3v2 mainboard housing in place and is angled at 45° to illuminate the print bed. Supports ARE NEEDED ... tons ... I recommend using Cura's tree supports, touching build plate only (unless you slice in a different program that does not offer that choice). Print in whatever orientation...
Topics: stl, 3D_Printer_Parts, Ender3v2, 3D Printer Accessories, Print bed light, thingiverse
4
4.0
May 1, 2021
05/21
by
Uncouth Selcouth (Conceptualiz3D)
data
eye 4
favorite 0
comment 0
I Think Therefore I Ham
Topics: stl, julia, mirrored, necklace, chaos, fine, math, regal, pendant, Jewelry, jewelry, fancy,...
6
6.0
May 1, 2021
05/21
by
Uncouth Selcouth (Conceptualiz3D)
data
eye 6
favorite 0
comment 0
PINKY! PINKY!
Topics: necklace, fine, Jewelry, jewelry, curvy, wavy, chaos, regal, nature, wavey, fancy, stl, twist,...
